C&M Britony FlexiFlu - User Manual

Britony FlexiFlue
Room Sealed Balanced Flue
MULTI POINT WATER HEATER
GGAASS SSAAFFEETTYY ((IINNSSTTAALLLLAATTIIOONN AANNDD UUSSEE)) RREEGGUULLAATTIIOONNSS..
I
t is the law that all gas appliances are installed by a competant person
in accordance with the above regulations.
Nat G.C. N° 52 980 08
L
PG G.C. N° 52 980 10
from serial number 894216759-04
IInnssttaallllaattiioonn
aanndd SSeerrvviicciinngg IInnssttrruuccttiioonnss
((lleeaavvee tthheessee iinnssttrruuccttiioonnss wwiitthh tthhee uusseerr))
The model number and serial number of this heater are on the data badge which is found inside rear
case at lower left hand side.
These numbers should be used when ordering replacement parts.
CCOONNFFOORRMMSS WWIITTHH EEUURROOPPEEAANN SSTTAANNDDAARRDD EENN..2266
c
c

Summary

GENERAL

Technical Data

Lists key technical specifications like heat input, gas rates, and water flow.

INSTALLATION REQUIREMENTS

Location

Specifies requirements for choosing a suitable installation location.

Siting the Flue Terminal

Provides guidance on positioning the flue terminal and required clearances.

Flue Terminal Assembly

Describes how to assemble and fit the flue terminal.

Electrical Connections

Details electrical safety and connection requirements.

INSTALLING THE APPLIANCE

Preparing and fitting the appliance

Fitting the flue

Gas Connection

Procedures for connecting the gas supply to the appliance.

Water Connections

Procedures for connecting the water inlet and outlet.

Electrical connections

Detailed steps for making mains electrical connections.

COMMISSIONING

Putting into Service

Steps for initial setup and putting the appliance into operation.

Gas Pressure

ROUTINE SERVICING

Burner

Heating Body

Main Gas Valve

REPLACEMENT OF COMPONENTS

Thermocouple

Spark Electrode

Thermoelectric valve

To Replace Fuse or PCB

To replace pressure switch

Adjustment of pressure switch

Detailed sequence for adjusting the pressure switch.

Replacement of Microswitch

Adjustment of Microswitch operating mechanism

Steps for adjusting the microswitch operating mechanism.

To replace the Gas and Water Section

FAULT FINDING CHART FOR BRITONY FLEXIFLUE

Pilot does not light

Identifies causes and remedies for pilot light failure.

Poor Pilot Flame

Lists potential issues and solutions for a weak pilot flame.

Pilot will not stay alight

Troubleshooting steps for when the pilot flame extinguishes.

Main burner does not light

Solutions for scenarios where the main burner fails to ignite.

Burner goes out on hot water demand

Addresses issues causing the burner to extinguish during use.

Explosive Ignition

Remedies for ignition that is too rapid or explosive.

Low Water Temperature

Identifies causes and solutions for insufficient hot water temperature.

Burner stays on

Addresses situations where the burner remains on unexpectedly.

Yellow Flames-Soot Formed

Unstable Flame

Insufficient Water

Identifies causes and solutions for low water flow.

C&M Britony FlexiFlu Specifications

General

Material	Plastic casing, copper heating element
Type	Instantaneous Electric Water Heater
Capacity	N/A (Instantaneous)
Installation	Wall-mounted
Power Rating	3.0 kW
Thermostat	Yes, adjustable
Overheat Protection	Yes
Inlet/Outlet	1/2" BSP