■ Fix the frames with the other 6 screws
4x16 mm in the specif holes (fig. 6).
■ Fasten the panel to the dishwasher door
with the screws 3.5 x 13 mm (fig. 7).
Drilling arrangements
■ Drill 12 mm deep holes in the panel
using a 2 mm diameter drill according to
the measures indicated in the figure 5.
■ Fasten the two supplied frames with 4 of
the 4 x 16 mm diameter screws, setting
them at the center of the eyelets (fig. 6).
■ Hang the panel on the dishwasher door
and align it by adjusting the frames with
the eyelets.
9
720 max.
645 min.
350 178
596,5 max.
=
=
572
6
7
5
8
Proceed as follows:
■ Open slightly the dishwasher door, let
the covering touch the base and mark its
lower edge on the base with a pencil; cut
out the interfering part.
Adaptation of the base
Sometime, in order to allow the door
rotation, a space must be cut out in the
base as indicated in the figure 8.
To Next Page
Loading...
