26
As soon as the low salt indicator is lit on the control panel ,salt should be topped
up.Always refill with special salt immediately before switching on the appliance.This
ensures that overrun special salt solution is immediately washed out and does not
corrode the rinsing tank.
Using special salt
Top up the salt as follows:
Water softening system
Only use dishwasher salt. Other products can cause damage to the appliance!
Any spilled salt causes corrosion.Run a programme after each refill.
1.Turn the cap clockwise to open the salt
container.
2.Fill with1 litre of water into the salt container.
3.Fill the tank up with specific salt(water
overflows).
4.Remove spilled salt from the opening area.
5.Turn the cap counter-clockwise to close
the salt container.
CAUTION
6.Press button for 3 sec after each
refill to reset salt aid indicator.
To Next Page
Loading...
