Candy CDIN 1L360PB - Programme Selection and Special Features

!
90
15. PROGRAMME SELECTION
AND SPECIAL FEATURES
! To turn the appliance on and off, press
the ON/OFF button (for at least 3
seconds).
! Connect the machine to the power
supply.
! Open the door, put the dishes to be
washed inside, and close the door again.
! Press the "ON/OFF" button and hold for
about 3 seconds.
! At this time only the “ON/OFF” and
”Progr.” buttons will be active, and all the
programme indicator lights will come on
for 3 sec. After this only indicator light
“P3” will stay on, and all the buttons will
still be active.
! Choose a programme with the
"PROGRAMME SELECTION" button.
! If you wish to select an option, press the
corresponding button (the indicator light
representing the selected option will
come on).
! Press "Start/Reset" and a signal will
sound, the indicator light corresponding to
the selected programme will stay on and
the wash indicator light will come on.
! Close the door (after an audible signal
has sounded, the programme will start
automatically).
! Open the door.
! Hold down the ON/OFF button for about
3 sec. to turn the machine on, and the
“P3”programme indicator light will come on.
From the Settings menu, you can adjust
various parameters to suit your washing
requirements.
Entering the Settings menu
! Open the door.
! Turn on the dishwasher by holding the
“ON/OFF” button down for about 3 sec.
! Hold down the “Progr.” and “ON/OFF”
buttons for about 5 sec.
! All the indicator lights will flash for 5 sec.
! The settings will be displayed:
- Lime scale prevention settings appear
when the indicator light comes on in the
corresponding programmes. If they are
all off, the level is set to "S0".
- When the audio signal is activated, the
"Express" indicator light comes on.
- When the “Memo” function is activated,
the "6h" indicator light on the start
delay function comes on.
! When you press the "Progr." button,
adjustment of SOFTENER will begin
(refer to the appropriate chapter in the
instruction booklet for information).
! Press the "Express" button to turn on
adjustment of the BUZZER. (refer to the
section on this topic for information on
how to adjust).
ON/OFF button
At the end of the cycle, remember to
switch off the appliance using the
ON/OFF button, then remove the plug
and close the water supply .
First time you switch on the
appliance
Next time you switch on the
appliance
If you have turned on the programme
memorisation function, the indicator
light corresponding to the last
programme completed will appear on
the display.
Settings Menu