! Press the "Start Delay" button to activate
the MEMO FUNCTION (refer to the
appropriate chapter in the instruction
booklet for information on how to turn it
on and off).
The dishwasher is equipped with a dirt sensor,
capable of analysing water murkiness during all
"AUTOMATIC" programme phases (see
programme legend). Thanks to this device,
the wash cycle parameters are automatically
adapted to the real quantity of dirt on dishes.
This is because water murkiness is linked to the
quantity of dirt on dishes. Thus, excellent
washing results are guaranteed while
optimising water and energy consumption.
The "IMPULSE" programmes use an
impulse washing technology, which reduces
consumption and noise, and improves
performance.
When the programme starts, you should
only open the door and add more dishes
when the ADDISH indicator light is
switched on. The appliance will stop
automatically and the time remaining to the
end of the cycle will flash on the display. Close
the door, without pressing any buttons.
The cycle will start from where it left off. When
the relating indicator light switches off, it is no
longer advisable to add further dishes.
Opening the door when a programme is
running is not recommended especially
during the main wash and final hot rinse
phases. However, if the door is opened
while a programme is running (for example,
to add dishes) the machine stops
automatically. Close the door, without
pressing any buttons. The cycle will start
from where it left off.
Proceed as follows to change or cancel a
running program:
! Hold the "RESET" button down for at
least 3 seconds.
! Some audible signals will sound and the
programme indicator lights will turn on
and off individually and sequentially
.