14
Appliance is not level. Readjust the feet.
The appliance is touching the wall or
other objects.
Move the appliance slightly.
Unusual noises.
A component, e.g. a pipe, on the rear
of the appliance is touching another
part of the appliance or the wall.
If necessary, carefully bend the
component out of the way.
The compressor does not start
immediately after changing the
temperature setting.
This is normal, no error has occurred. The compressor starts after a
period of time.
Water on the floor or storage
shelves.
Water drain hole is blocked. See the “cleaning and care”
section.
Changing the light bulb
Warning!
Before changing the light bulb, switch off the appliance and unplug it, or pull the fuse
or the circuit breaker.
Light bulb data: 220-240 V, max. 15 W
To switch off the appliance, set the temperature regulator to position Ā0ā.
Unplug the mains plug.
Press the bulb in the center with finger.
Take out the lampshade with screwdriver, change the bulb, and then replace the lampshade..
Put the refrigerator back into operation.
Noises during Operation
The following noises are characteristic of refrigeration appliances:
Clicks
Whenever the compressor switches on or off, a click can be heard.
Humming
As soon as the compressor is in operation, you can hear it humming.
Bubbling
When refrigerant flows into thin tubes, you can hear bubbling or splashing noises.
Splashing
Bulb(inside)
Lampshade
Thermostat knob
To Next Page
Loading...
