Power Management Function
it is possible to set a maximum power absorption level for the induction hob, choosing up to different
power ranges.
induction hobs are able to limit themselves automatically in order to work at lower power, to avoid
the risk of overloading.
It is not necessary to put any pots on the heating zones. We suggest to start setting within 5
seconds after connecting the power. You need to enter the power setting mode within 60
seconds
to enter Power Management Function.
To enter Power Management Function
1. Please be noted that do not turn on the
hob. At this stage, press “Boost” and “Lock” at the
same time.
The “S” symbol will be displayed on zone #1.
The symbol “S” will be displayed on zone #1 and
symbol “E” will be displayed on zone #2.
3. Press “Boost” and “Lock” keys at the same
time again.
The symbol “S” will be displayed on zone #1, “E”
will be displayed on zone #2, and “t” will be
displayed on zone #3. At the same time, the
current maximum power mode (7.2) will be
displayed on the timer indicator.
To switch to another level
short press the “Boost” key
Confirmation Power Management Function
There are 6 power levels, from “7.2” to “2.5”. The
timer indicator will show one of them.
“7.2” : the maximum power is 7.2kW.
“6.5” : the maximum power is 6.5kW.
“5.5” : the maximum power is 5.5kW.
“4.5” : the maximum power is 4.5kW.
“3.5” : the maximum power is 3.5kW.
“2.5” : the maximum power is 2.5kW.
To Next Page
Loading...
