Candy CO4474TWM6/1-S - User Manual

Questions and Answers

C
Christopher RamosAug 7, 2025
Why does my Candy CO4474TWM6/1-S not work or start?
- M
  Mr. David TaylorAug 7, 2025
  To ensure your Candy Washer starts, verify it's plugged into a working socket and that the power is on. Check the wall socket with another appliance. Make sure the door is correctly closed, and the required program is selected with the start button pressed. Also, confirm the washer isn't in pause or time delay mode.
T
Tyler JonesAug 11, 2025
What to do if water leaked on the floor near Candy CO4474TWM6/1-S Washer?
- L
  Lauren WardAug 11, 2025
  If you notice water leaking near your Candy Washer, it could be from the seal between the tap, supply hose, and fill valve. Try replacing the seal and tightening the hose connections. Also, check that the front filter is correctly closed.
M
Marcus Evans DVMAug 15, 2025
Why Candy Washer does not spin?
- S
  Stephanie FrankAug 15, 2025
  If your Candy Washer isn't spinning, try these steps: First, remove and de-tangle the load, then reload and restart the spin program. If water hasn't completely drained, wait a few minutes. Ensure that the "no spin" function isn't selected and check the selected options' effect on the spin cycle. Also, too much detergent can impede spinning, so use the correct amount.
S
Shawn WrightAug 20, 2025
How to stop strong vibrations during spin cycle of Candy CO4474TWM6/1-S?
- C
  Claire DayAug 20, 2025
  If your Candy Washer is making strong vibrations or noises during the spin cycle, it might not be fully leveled. Adjust the feet as needed. Also, ensure that the transport screws, rubber bungs, and spacer tubes were removed. Finally, check for any foreign objects like coins or buttons inside the drum.
T
Thomas BrooksAug 25, 2025
What to do if Candy Washer displays E2 error?
- A
  Andrew JosephAug 25, 2025
  If your Candy Washer displays 'E2' or the LEDs flash twice, make sure the water supply tap is open and the supply hose isn’t bent, kinked, or trapped. Ensure the drain pipe is at the proper height. Close the tap, unscrew the filler hose, and clean the anti-sand filter. Finally, check the filter for clogs or foreign objects.
R
rickypearsonAug 28, 2025
How to fix E7 error on Candy CO4474TWM6/1-S?
- I
  ijamesAug 28, 2025
  If your Candy Washer displays 'E7' or the LEDs flash seven times, ensure the door is correctly closed and that clothes aren't preventing it from fully closing. If the door is locked, turn off and unplug the washer, wait 2-3 minutes, and reopen the door.
J
jessica47Sep 2, 2025
What to do if Candy CO4474TWM6/1-S displays E4 error?
- P
  paulnicholasSep 2, 2025
  If your Candy Washer displays 'E4' or the LEDs flash four times, ensure you're using the correct amount of detergent designed for washing machines.