4
z Units are supplied with isobutene (R600a). In any case the label inside the unit shows
the type of refrigerant used. All units must be transported and installed with the
utmost care since any exclusive knocking or shaking could damage the refrigerating
circuit.
z Failure to comply with the above mentioned requirement might result in the unit not
being able to function with either R134a or R600a. Further more, in the presence of
R600a, any damage to the refrigerating circuit could lead to the risk of explosion
caused by outside sparks or flames.
In the event of damage, contact the nearest service center, ventilate the room where
the machine is located and avoid exposure to flames or any repair work on the unit.
Caution do not use electrical equipment inside the food storage compartment.
z A transparent polythene film protects the side panels and door on the appliance. This
film must be removed prior to installation. The film guarantees intact finished surfaces
of the appliance and prevents scratches or other damages during transport. Simply
remove by hand and dispose of as recyclable plastic material.
INSTALLATION
Positioning
Position the appliance away from sources of heat such as stoves, radiators, direct sunlight
etc. Maximum performance and safety are guaranteed by maintaining the correct indoor
temperature for the class of unit concerned, as specified on the rating plate.
Climate classification Ambient temperature
SN
10~32℃
N
16~32℃
ST
16~38℃
T 16~43℃
Appliances must not be exposed to rain. Sufficient air must be allowed to circulate in the
lower rear section of appliances, as poor air circulation can affect performance. Built-in
appliances should be positioned away from heat sources such as heaters and direct
sunlight.
Electrical connection
Before connecting the appliance to the power supply, ensure that the voltage
and
frequency as indicated on the data plate correspond to those of the electrical mains.
A deviation of –6V to +6V is admissible with respect to the rated voltage. For operation
with other voltage supplies, a right autotransformer is required.
Always connect the appliance to an useful earthing system
For the above, if the main supply is not earthed, connect the appliance to a separate
earthing system. Consult a specialized technician to carry out the latter in compliance with
current standards.
The manufacturer declines all responsibility for failure to observe the above accident
prevention standards.
To Next Page
Loading...
