1. Remove the kickplate.
2. Turn the locking levers clockwise and pull
out the condenser.
3. Pull out the condenser unit.
4. Gently remove any dust or fluff with a
cloth, then wash the unit by holding it
under a running tap turning it so that
water flows between the plates, to
remove any dust or fluff.
5. Refit the condenser ensuring it is in the
correct way (as indicated by the arrow)
and pushed firmly into place.
6. Lock the levers by turning them anti-
clockwise. Be sure that condenser unit
fixed to the basement tightly.
7. Refit the kickplate.
To Next Page
Loading...
