Candy CUQS 58EW - Installation

22
9 - Installation
EN
9.1 Unpacking
▶
WARNING!
▶ The appliance is heavy. Always handle with at least two persons.
▶ Keep all packaging materials out of childrens reach and dispose them in an environ-
mentally friendly manner.
Take the appliance out of the packaging.
▶ Remove all packaging materials.
9.2 Environmental conditions
the temperature inside the appliance and its energy consumption. Do not install the appli-
ance near other heat-emitting appliances (ovens, refrigerators) without isolation.
9.3 Space requirements
Required space to open the door (Fig. 10.1):
Width
in mm
Depth
in mm
Distance to wall
in mm
W1 W2 D1 D2 D3 D4
545 838 480 968 1046 100
10.4 Ventilaton cross-section
FOR a free standing appliance: this refrigerating
appliance is not intended to be used as a built-in
appliance.
safety reasons, the information of the required ventila-
tion cross sections must be observed (Fig. 10.2).
10.5 Aligning the appliance
The appliance should be placed on a at and solid sur-
face. If the appliance is placed on a pedestal, strong and
foam packing material as a pedestal.
1. Tilt the appliance slightly backwards (Fig. 10.3).
2. Set the feet to the desired level.
3. The stability can be checked by alternately bump-
ing on the diagonals. The slight swaying should be
the same in both directions. Otherwise the frame
can warp; possible leaking door seals are the result.
A low tendency to the rear eases the closing of the
door.
W2
D1
D3
D2
W1
D4
9.1
10 cm
10 cm
10 cm
10 cm
9.2
max 45°
1.
2.
3.
9.3
The room temperature should always be between 10 °C and 38 °C, since it can influence
Model
identifier
CUQS
58EW*
CUQS
513EW*
545 838 500 988 1066 100