To exit remote control, press
"PROGRAMME SELECTION" for 3 sec.
When no cycle is under way:
Indicator lights P3 P4 will go off and the
led corresponding to the last programme
the machine completed (or P3) will come
on.
When a cycle is under way:
Indicator lights P3 P4 will start flashing,
while the programme phase indicator
lights will show the point in the washing
cycle that the machine has reached.
The cycle will be completed without
control from the app.
Alternative way to exit remote control.
Press "START/RESET" and hold down
for 3 sec.: if there is a cycle under way, it
will be cancelled, and the machine will
exit REMOTE CONTROL mode. You
may now set a new wash cycle using the
control panel.
If you turn the machine off and turn it
back on with the On/Off button while
REMOTE CONTROL is enabled and a
cycle is under way (or if the power
supply is interrupted), the cycle will
resume from the point at which it was
interrupted. "REMOTE CONTROL" will
be disabled and indicator lights P3
and P4 will flash.
To Next Page
Loading...
