14
Important! Ethereal oils and organic solvents can
attack plastic parts, e.g. lemon juice or the juice
form orange peel, butyric acid, cleanser that
contain acetic acid.
• Do not allow such substances to come into
contact the appliance parts.
• Do not use any abrasive cleaners
• Remove the food from the freezer. Store them
in a cool place, well covered.
• Switch the appliance off and remove the plug
from the mains, or switch off or turn out the
circuit breaker of fuse
• Clean the appliance and the interior accessories
with a cloth and lukewarm water. After cleaning
wipe with fresh water and rub dry.
• After everything is dry place appliance back into
service.
Troubleshooting
Caution! Before troubleshooting,
disconnect the power supply. Only a
qualified electrician of competent
person must do the troubleshooting
that is not in this manual.
Important! There are some sounds during normal
use (compressor, refrigerant circulation).
If the malfunction shows again, contact the
Service Center
These data are necessary to help you quickly and
correctly. Write the necessary data here, refer to
the rating plate.
Problem Possible cause Solution
Appliance
dos not work
plugged in or is
Insert mains plug.
Fuse has blown or
is defective
Check fuse, replace
if necessary.
Socket is defective
are to be corrected
Appliance
freezes or
cools loo
much
Temperature is set
too cold or the
appliance runs at
SUPER modes,
temperature
regulator to a
warmer setting
The food is
not frozen
enough.
Temperature is not
properly adjusted.
initial Temperature
an extended
as long as
Problem Possible cause Solution
warm food was
placed in the
appliance within
temperature
regulation to a
colder setting
The appliance is
near a heat source.
installation
Heavy build
up of frost
on the door
seal.
Door seal is not air
light.
leaking sections of
the door seal with
a hair dryer (on a
cool setting) At the
same time shape
the warmed door
seal by hand such
that it sits
Unusual
noises
Re-adjust the feet.
touching the wall
Move the
appliance slightly.
a pipe on the rear
of the appliance is
touching another
part of the
appliance or the
If necessary,
carefully bend the
component out of
the way
Side panels
are hot
exchange is in the
touch side panels if
If the malfunction shows again, contact the
Service Center.
These data are necessary to help you quickly and
correctly. Write the necessary data here, refer to
the rating plate.