The water softener can treat water with a hardness level of up to 60°Fh (French grading) or 33°Dh (German grading) through 5 settings.
The settings are listed in the panel below:
Regulating the water softener with electronic programmer
Level
Water hardness
°fH (French)
Water hardness
°dH (German)
Use of regenerating
salt
Water softener
setting
0
1
2
3
4
0-8
9-20
21-30
31-40
41-60
4
5-11
12-17
18-22
23-33
no
yes
yes
yes
yes
USE
15 GB
Indicator light 1
Indicator light 1+2
Indicator light 1+2+3
Indicator light 1+2+3+4
WARNING!
If any problem occurs, turn thedishwasher off by pressing the "ON/OFF" button and start the procedure again from
the beginning (STEP 1).
"PROGRAMME SELECTION"switch on"ON/OFF"
"PROGRAMME SELECTION"UNTIL "PRO-
GRAMME SELECTION"
level 5level 0
"ON/OFF"
IMPORTANT
The dishwasher must ALWAYS be off before start of this procedure.
CONSUMPTION (main programmes)*
* Values are measured in a laboratory according to European Standard EN 50242 (consumption may
vary according to conditions of usage).
Programme
Universal
Hygiene+
Eco
Rapid 32'
1,25
0.93
0.67
0,60
15
12
Energy (kWh) Water (L)
Information for the test laboratories General programme comparison
Ref. EN 50242 standards:
1) Normal load
2) Shine setting: "4"
3) Amount of detergent: 18gr. for wash
WASHING PROGRAMME
PROGRAMME SELECTION BUTTON
LEDs
To Next Page
Loading...
