Candy WashPass - Initial Setup and Configuration; SMART RING and First Start; Water Hardness and Detergent Dosing; Play;Pause Button Usage

!
12
! When the SMART RING is turned, the
appliance will be turned on and the
display will show the description and
parameters of the selected programme.
! At the end of the cycle, remember to
switch off the appliance by turning the
SMART RING to the OFF position, then
unplug the appliance and turn off the
water supply.
- Language setting
! After connecting the machine to the
network and turning it on, press the
STEAM or DELAY START button to
display the available languages.
! Select the desired language pressing the
PLAY/PAUSE button.
- Change the language
If you want to change the setting language
you will have to press simultaneously
STEAM and DELAY START buttons for
about 3 seconds. ENGLISH will appear on
the display, and you will be able to choose
a new language.
- Water Hardness setting
This appliance, is able to dose your
detergent automatically. The optimum
quantity of detergent depending on the
water hardness, on the load quantity and on
the chosen cycle (cotton, delicates, etc...)
Water Hardness level:
L1 = LOW (0-12 °fH o 0-7 °dH)
L2 = MEDIUM (13-30 °fH o 8-17 °dH)
L3 = HIGH (≥ 30 °fH o ≥ 17 °dH)
! To confirm the standard water hardness
level set by the factory, press PLAY/
PAUSE button.
! If you want to change the standard water
hardness setting (and consequently the
amount of detergent dispensed), press
STEAM or DELAY START button.
! Once chosen the water hardness level,
confirm by pressing the PLAY/PAUSE
button.
- Change the water hardness setting
! If you want to change the water hardness
setting (and consequently the amount of
detergent dispensed), hold down the
STEAM and DELAY START buttons for a
few seconds. The wording WATER
HARDNESS will appear on the display
and you can choose the desired level by
pressing the STEAM or DELAY START
button again. The higher the water
hardness, the more detergent will be
dispensed.
! Confirm by pressing the PLAY/PAUSE
button.
WARNING:
Don’t touch the buttons while inserting
the plug because the machines
calibrates the systems during the first
seconds: touching the buttons, the
machine couldn’t work property. In
this case, remove the plug and repeat
the operation.
SMART RING (ring for selecting
programmes)
First starting
The default setting for the water
hardness is set in the factory at level 2
(L2) as this satisfies the requirements
of the majority of users.
WARNING:
Follow now chapter REMOTE
CONTROL (WI-FI) indications to set up
the App and the autodose detergent
system.
PLAY/PAUSE button
Close the porthole BEFORE pressing
the PLAY/PAUSE button.