What to do if my Cannon Indoor Fireplace lights but goes into lockout?
If your Cannon Indoor Fireplace lights but then goes into lockout, test the flame for the correct ionization signal. You can connect a multimeter in series with the flame rod and set the function to measure micro-amps. The module will go into lockout if the flame current sensitivity is less than 0.5 micro-amps.
Why won't my Cannon Indoor Fireplace heater start, and no indicator lamps are on?
If your Cannon Indoor Fireplace heater won't start and no indicator lamps are on, first, check that the electricity supply is correct. If the Neutral and Active wires are incorrectly connected, the control module will not function.
What to do if there is no gas to burner in my Cannon Indoor Fireplace?
If there's no gas going to the burner of your Cannon Indoor Fireplace, the gas valve should open at the same time as the igniter sparks. Check the solenoid coils for continuity. Also, verify that gas pressure is present at the test point when the spark is being generated and that there is gas to the inlet of the gas control.
How to fix a spark that is being produced but not at the burner in my Cannon Indoor Fireplace?
If spark is being produced but not at the burner of your Cannon Indoor Fireplace, ensure spark is present between the electrode and burner. Check that the spark lead is connected into the module and check the continuity of the ht cable. Also, check that there is no short circuit to earth and spark gap is correct, the wall socket to the appliance has correct polarity, the sense electrode is in flame and the appliance is earthed correctly. Listen for a cracking sound, which indicates a misdirected spark; inspect the spark ceramic insulator for cracks.
Why does the fuse keep blowing in my Cannon Indoor Fireplace?
If the fuse keeps blowing in your Cannon Indoor Fireplace, check the solenoid coils for signs of being shorted. Also, inspect the fan and wiring for any short circuits.
Steps to follow immediately if a gas leak is detected from the appliance.
Key safety precautions regarding installation, operation, and maintenance of the heater.
How to power the heater and use the ON/OFF, LOW, MEDIUM, and HIGH controls.
Explanation of the ignition process, flame establishment, and fan operation.
Diagnosing problems related to spark production and ignition failure.
Troubleshooting flame issues, lockout conditions, and fuse blowing.
Diagnosing why the heater will not start, including no indicator lamps.
Understanding the green and red LED indicators on the ignition controller.
Interpreting fault codes for normal startup, operation, and ignition failures.
Procedures for checking and adjusting gas pressure for Natural and Propane gas.
General| Brand | Cannon |
|---|---|
| Model | Fitzroy Powerflue In-built |
| Category | Indoor Fireplace |
| Language | English |
To Next Page
