Carefully roll the front wheel in-between the brake pads and verify
the brake pads sit in-line with the rim.
Carefully align and lower the fork dropout onto the wheel axle. Ensure
the wheel is fully seated into the fork dropouts on both sides.
While holding the lever head of the skewer, begin tightening the
adjusting nut in a clockwise direction. Remember, “righty tighty”.
Close the lever. If you don’t feel signicant tension when the lever is
closed, open the lever and continue tightening the adjusting nut until
adequate tension is achieved. When properly tightened, the lever
should leave a mark in your hand.
F.
G.
H.
SET-UP STEP 2STEP 1 STEP 3 STEP 4 PRE-RIDE CHECK
E
F
G
H
To Next Page
Loading...
