Canon EOS C300 Mark III - Terminal and the HDMI out Terminal; Selecting the Video Outputs Scan Mode; Superimposing Onscreen Displays on Video Outputs

Connecting to an External Monitor or Recorder
152
• The time code will not be output from the HDMI OUT terminal in the following cases.
- In MEDIA mode.
- When the video output signal is 720x480 / 59.94P or 720x576 / 50.00P.
Enabling simultaneous output from the MON. terminal and the HDMI OUT terminal
You can simultaneously output the same video signal from the MON. terminal and the HDMI OUT terminal.
Select > [B System Setup] > [MON&HDMI Simult. Output] > [On].
• The output resolution will be 1920x1080P when [MON./HDMI Scan Mode] is set to [P], and 1920x1080i when
set to [PsF (Forced 1080i)].
NOTES
• The following functions cannot be used when [MON&HDMI Simult. Output] is set to [On].
> [B System Setup] > [HDMI Max Res.], [Linked to HDMI Monitor] or [MON. Output Resolution].
Selecting the Video Output’s Scan Mode
When using external devices that support only interlaced scanning, you can change the scan mode of the video
signal output from the various terminals.
MON. Terminal / HDMI OUT Terminal
Select > [ B System Setup] > [MON./HDMI Scan Mode] > [P] or [PsF (Forced 1080i)].
SDI OUT Terminal
Select > [B System Setup] > [SDI OUT Scan Mode] > [P] or [PsF (Forced 1080i)].
NOTES
• During slow & fast motion recording, [SDI OUT Scan Mode] cannot be used.
Superimposing Onscreen Displays on Video Outputs
You can output the camera's onscreen displays along with the video output from the MON. terminal or HDMI
OUT terminal to check the onscreen displays on an external monitor. This setting will not affect your recordings.
Select > [ ¢ Monitoring Setup] > [OSD Output: MON./HDMI] or [OSD Output: SDI OUT] > [On].
• T appears on the right of the screen (In CAMERA mode, only if > [ ¢ Monitoring Setup] >
[Custom Display 2] > [OSD Output] is set to [On]).
NOTES
• When the HDMI OUT terminal’s output resolution is 720x480 or 720x576, the camera’s onscreen displays will
not be output from the HDMI OUT terminal.
• For video output from the SDI OUT terminal, only onscreen displays can be superimposed. Assistance
functions that affect the image (such as false color and magnification) will not be superimposed.