Setup Screens and Menu Options
190
[Monitoring Setup] (
¢
) menu
Submenu levels / Menu items Setting options and additional information
[Control Display] (A 31)
[Camera]
[Brightness] 1 to 5 (3)
[Turn Off Display] [Assignable Buttons], [Auto (Remote OU-700)]
[Remote OU-700]
[Brightness] 1 to 5 (3)
[EVF-V70]* (A 42)
[Brightness], [Contrast] –99 to 99 (±0)
[Color] –20 to 20 (±0)
[Sharpness] 1 to 4 (2)
[Luminance] [Normal], [High]
[Eye Sensor] [On], [Off]
When this setting is set to [On], the optional viewfinder will be dimmed automatically when the
sensor does not detect the user’s eye near the eyepiece for 30 seconds (or 10 seconds, in playback
mode).
[Surrounding Area]
[Activate] [On], [Off]
When this setting is set to [On], the image from the camera will be reduced and some of the
surroundings around the recorded frame will be shown on the shooting screen.
[Select] [Line], [Mask 25%], [Mask 50%], [Mask 75%]
You can use a color line or apply masking to the non-recorded areas to distinguish the area covered
by the recorded frame from the surroundings. If you selected [Line], you can select the color of the
border line with the [Line Color] setting.
[Line Color] [Yellow], [Blue], [Green], [Red], [Black], [Gray], [White]
[Anamorphic] (A 122)
[Desqueeze Ratio] [Lens Squeeze Factor], [x2.0], [x1.3]
[VIDEO Output],
[MON.+HDMI Output]
[On], [Off]
[LUT]* (A 154)
[MON. 1], [MON.2],
[SDI OUT 1/2/3/4], [SDI OUT 1/2],
[SDI OUT 3/4], [HDMI]
[BT.709], [BT.2020], [DCI], [ACESproxy], [HDR-ST 2084], [Off]
[VIDEO] [BT.709], [ST 2084 Assist. (1600%)], [ST 2084 Assist. (400%)], [Off]
[B&W Image]
[VIDEO Output],
[MON.+HDMI Output]
[On], [Off]
When this setting is set to [On], the live image from the camera displayed on the optional viewfinder
(VIDEO terminal) or on an external monitor (MON. terminals or HDMI OUT terminal) to black & white. If
enabled, onscreen displays will appear in color.
[OSD Output] (A 155)
[VIDEO]
[Output] [On], [Off]
[Peripheral Border] [On], [Off]
[MON.+HDMI]
[Output] [On], [Off]
[Peripheral Border] [On], [Off]