Canon F-718S - Before Using the Calculator

7
To se lec t the statisti cal dis play format [ 3] STAT
([1] ON or [2] OFF)
[1] ON: Show FREQ (Frequency) Column in Statistical
Data Input Screen
[2] OFF: Hide FREQ (Frequency) Column in Statistical
Data Input Screen
To se lec t the decima l point d isplay form at [4] Di sp ([1] Dot or
[2] Comma)
[1] Dot: specify dot format for Decimal point result display
[2] Comma: specify comma format for Decimal point
result display
To Adjust Display co nt ra st [5 ] CONT
See “Display Contrast Adjustment” section.
Before Using the Calculator
Check the current Calculation Mode
Be sure to check the status indicators that indicate the
current calculation mode (COMP, STAT, TABLE), display
formats setting and angle unit setting (Deg, Rad, Gra)
Return to initial setup
Pressing (YES) to return the
initial calculator setup
Calculation mode : COMP
Input/Output Format : Maths
Angle unit : Deg
Display Digits : Norm 1
Fraction Display Format : d/c
Statistical Data Input : OFF
Decimal Point format : Dot
This action will not clear the variable memories.
Initialize the calculator
When you are not sure of the current calculator setting, you
are recommended to initialize the calculator (calculation
mode “COMP”, angle unit “Degree”, and clear reply and
variable memories), and LCD contrast by pressing
(All) (YES) .