83
Recording
Pressing will not start recording.
- You cannot record while the camcorder is writing previous recording onto the memory (while the ACCESS
indicator is on or flashing).
- The memory is full or it already contains 999 scenes (the maximum number of scenes). Delete some
recordings ( 41, 58) or initialize the memory ( 30) to free some space.
The point where was pressed does not match the beginning/end of the recording.
- There is a slight interval between pressing and the actual start of recording. This is not a
malfunction.
The camcorder will not focus.
- Autofocus does not work on the subject. Focus manually (
46).
- Lens is dirty. Clean the lens with a soft lens-cleaning cloth (
96). Never use tissue paper to clean the lens.
A vertical light bar appears on the screen.
- Bright light in a dark scene may cause a vertical light bar (smear) to appear. This is not a malfunction.
Changing the operating mode between recording ( )/record pause ( )/playback ( ) takes longer than
usual.
- When the memory contains a large number of scenes, some operations may take longer than usual. Back up
your recordings ( 68) and initialize the memory ( 30).
Reviewing the last scene recorded takes longer than usual.
- This may occur as movies and still images are recorded/deleted over time. Back up your recordings ( 68)
and initialize the memory ( 30).
Movies or still images cannot be recorded properly.
- This may occur as movies and still images are recorded/deleted over time. Back up your recordings ( 68)
and initialize the memory ( 30).
Playback
Cannot add scenes to the playlist.
- The playlist cannot contain more than 99 scenes or 100 hours of scenes.
- You may not be able to add scenes to the playlist if they were recorded or edited using another device.
Cannot delete a scene.
- You may not be able to delete scenes recorded or edited using another device.
Deleting scenes takes longer than usual.
- When the memory contains a large number of scenes, some operations may take longer than usual. Back up
your recordings ( 68) and initialize the memory ( 30).
Cannot erase a still image
- The still image is protected. Remove the protection ( 60).
Start/Stop
Start/Stop
Start/Stop
COPY
Downloaded From VideoCamera-Manual.com Manuals
To Next Page
Loading...
