Canon FS10 - Page 91

91
COMMUNICATION ERROR
- The printer is experiencing a data transfer error. Cancel printing, disconnect the USB cable and turn off the
printer. After a while, turn the printer back on and reconnect the USB cable. When you are printing using the
button, check the print settings.
Or, you attempted to print from a memory card that contains a large number of images. Reduce the number of
images.
COULD NOT PRINT X IMAGES
- You attempted to use the print order settings to print X images that were recorded with another camcorder,
with a different compression or were edited on a computer.
FILE ERROR
- You attempted to print an image that was recorded with another camcorder, has a different compression, or
was edited on a computer.
HARDWARE ERROR
- Cancel printing. Turn off the printer and turn it back on. Check the printer status. If the printer is equipped with
a battery, it might be exhausted. In such case, turn off the printer, replace the battery and turn it back on.
INCOMPATIBLE PAPER SIZE
- The paper settings of the camcorder conflict with the printer’s settings.
INK ABSORBER FULL
- Select [CONTINUE] to resume printing. Consult a Canon Service Center (refer to the list included with the
printer) to replace the ink absorber.
INK ERROR
- There is a problem with the ink. Replace the ink cartridge.
LOW INK LEVEL
- The ink cartridge needs to be replaced soon. Select [CONTINUE] to restart printing.
NO INK
- The ink cartridge is not inserted or is out of ink.
NO PAPER
- Paper is not correctly inserted or there is no paper.
NO PRINTHEAD
- No print head is installed in the printer or the print head is defective.
PAPER ERROR
- There is a problem with the paper. The paper is not correctly loaded or the paper size is wrong. Alternatively,
if the paper output tray is closed, open it to print.
PAPER JAM
- The paper jammed during printing. Select [STOP] to cancel printing. After removing the paper, set some paper
again and retry printing.
PAPER LEVER ERROR
- Paper lever error occurred. Adjust the paper selection lever to the proper position.
COPY
Downloaded From VideoCamera-Manual.com Manuals