Canon imagePROGRAF iPF6300S Setup Guide

10
Connect the printer to a computer
15
Click Quit.
The software installation is now
completed. Next, connect the printer to
the computer.
17
Click Next.
18
Select the printer to setup and
click Next.
MEM
O
• To register the printer by entering its IP
address, click Registering IP Address.
Enter the IP address of the desired
printer in IP Address and click Next.
19
After entering your preferred name for
the printer in Printer Name and the
installation location in Location, click
Register.
23
Next, install the electronic manuals.
Insert the provided User Manuals
CD-ROM in the CD-ROM drive.
24
Double-click the iPFxxxx Manual
Installer icon on the CD-ROM. (iPFxxxx
represents the printer model.)
25
Select the region where the printer will
be used and the language of the user
manual to install, and then click OK.
26
Check the message and click Continue.
27
After reading the software license
agreement, click Continue.
28
Click Agree.
Make sure that the printer is on, and then connect the printer to the computer or the network
with a cable.
• For USB connections
• For network connections
MEM
O
• Be careful not to insert the USB cable into the Ethernet port.
1616
Select the printer to setup
20
Click Finish.
MEM
O
• To register another printer, click
Continue Registration, and repeat
steps 17 to 19.
21
Click OK.
MEM
O
• If the same model of printer is already
registered on the computer, a screen is
displayed for printer selection. Select
the desired printer and click Next.
22
The following screen is displayed and
paper information is updated. When the
paper information has been updated, the
screen is no longer displayed.
Install the electronic manuals

Canon imagePROGRAF iPF6300S Specifications

General

Brand	Canon
Model	imagePROGRAF iPF6300S
Category	Printer
Language	English