67
Routine■Maintenance
Loading Pre-Punched Paper
You can load pre-punched paper in a paper drawer or the multi-purpose tray. When loading pre-punched paper, take note
of the orientation of the binding holes and the image.
When the paper is loaded into the multi-purpose tray, the side facing down is the one printed on.
• If you want to output prints with the printed face down, select plain paper with horizontal (landscape) orientation in
[Select Paper]. (See e-Manual > Basic Operations.)
Loading Transparencies
You can load transparencies in the multi-purpose tray and the paper drawers.
Transparencies have a front and back side. Load transparencies correctly to achieve sharp printing results.
When the paper is loaded into the multi-purpose tray, the side facing down is the one printed on.
• You can load onlyLTR size transparencies in paper drawers 2, 3, 4, and multi-purpose tray.
• When loading transparencies, make sure to hold only the edges of the sheets and avoid touching the print surface.
• Do not load transparencies while the machine is printing. Doing so may cause a paper jam.
• Use only transparencies intended for use with this machine. If you use other transparencies, you may cause damage to the
machine.
• It is recommended that output transparencies are immediately removed from the output tray to avoid folding of the
transparencies and paper jams.
• Return the remaining transparencies to their original package for storage, avoiding locations subject to high temperatures
and humidity. Leaving transparencies loaded for an extended period of time may cause the sheets to stick together and
result in a paper jam.
• Leaving transparencies loaded for an extended period of time may cause the sheets to stick together and result in
diculties feeding the transparencies. In this case, fan the loaded transparency sheets, or if you have loaded 50 or more
sheets, reduce the number of sheets to less than 50 or use new transparencies.
• When printing on transparencies, depending on the type of image, the image may become dense. When this happens,
adjust the density for the output image.
If a paper jam occurs, fan the loaded transparency sheets well.
To Next Page
Loading...
Need help?
General
