Canon IMAGERUNNER ADVANCE C5030 User Manual

xxiii
Periodic Inspection of the Breaker
This machine has a breaker that detects excess current or leakage current. Make sure to test the breaker once or twice a
month using the following procedure.
Make sure that the main power is turned OFF, before inspecting the breaker.
If a malfunction occurs after an inspection, contact your local authorized Canon dealer.
Checking the Breaker
1 Push the test button on the rear of the machine with the tip of a ball-point pen, or a similar
object.
Briefly push the test button.
The breaker is located on the rear of the machine.
For more information on the location of the breaker, see e-Manual > Before You Start Using This Machine.
2 Confirm that the breaker lever is switched to the OFF (" " side) position.
ON
( I side)
OFF
( side)
Do not use the test button to turn the power ON and OFF.
If the breaker lever does not switch to the OFF (" " side) position, repeat step 1.
If the breaker lever does not switch to the OFF (" " side) position, despite carrying out the above procedure two or three times,
contact your local authorized Canon dealer.
•
•
•
•
•
•
•

Canon IMAGERUNNER ADVANCE C5030 Specifications

General

Print Resolution	1200 x 1200 dpi
Scan Resolution	600 x 600 dpi
Copy Resolution	600 x 600 dpi
Duplex Printing	Yes
Print Speed	30 ppm (black/color)
Copy Speed	30 cpm (black/color)
Fax Resolution	400 x 400 dpi
Connectivity	Ethernet, USB 2.0
Type	Color Laser
Supported Paper Sizes	A4, A5, B5, Legal, Letter
Display	8.4-inch SVGA Full Color TFT Screen
Paper Capacity	Standard: 1, 200 sheets; Maximum: 5, 000 sheets