Canon iP3000 - Page 10

10
5) After the function (menu) is selected, press the Power button. The LED lights in green, and the
selected function is performed. (When the operation completes, the printer returns to the menu
selection mode automatically.)
<Destination settings procedures>
In the destination settings mode, press the Resume/Cancel button the specified number of time(s)
according to the destination listed in the table below, and press the Power button.
Times LED Destination
1 time Orange Japan: iP3100
2 times Green Other than Japan, non-support of CD-R printing (A4): iP3000
3 times Orange Other than Japan, non-support of CD-R printing (LTR): iP3000 (LTR)
4 times Green Other than Japan, support of CD-R printing (A4): iP3000
5 times Orange Other than Japan, support of CD-R printing (LTR): iP3000 (LTR)
6 times or more Return to the menu selection
Note: After setting the destination, confirm the model name in service test print or EEPROM information
print. (See APPENDIX 1, SERVICE TEST PRINT or APPENDIX 2, EEPROM INFORMATION
PRINT.)