5
3. ERROR DISPLAY
Errors are indicated by the LED, and warnings are displayed on the monitor of the computer connected
to the printer.
3-1. Operator Call Error (LED Blinking in Orange)
LED
blinking
Error [Error code] Corrective action Remarks
No paper. (ASF) [1000] Set the paper in the ASF, and press
the Resume/Cancel button.
No CD-R tray. [1001]
*1
Set the CD-R tray, and press the
Resume/Cancel button.
2 times
No paper in the cassette. [1003]
(No paper in the front paper
feed cassette.)
Set the paper in the cassette, and
press the Resume/Cancel button.
Paper jam. [1300]
Paper jam in the under guide.
[1304]
Paper jam in the rear guide.
[1303]
Remove the jammed paper, and
press the Resume/Cancel button.
3 times
Front door closed. [1250] Open the paper output tray.
4 times No ink.
[1601 / 1611 / 1612 / 1613]
Replace the empty ink tank(s), or
press the Resume/Cancel button.
Pressing the Resume/Cancel
button will exit the error without
ink tank replacement, however,
ink may run out during printing.
5 times The print head is not installed
[1401], or it is not properly
installed (EEPROM data of the
print head is faulty) [1403 /
1405].
Install the print head properly, and
close the access cover.
Or, with the print head installed, turn
the printer off and on.
Inner cover open. [1841]
*2
Close the inner cover, and press the
Resume/Cancel button.
Inner cover open (during
printing on paper). [1846]
*2
Close the inner cover, and press the
Resume/Cancel button.
CD-R tray guide closed (during
CD-R printing).
[1850 / 1855]
*1
Open the CD-R tray guide, set the
CD-R tray properly, and press the
Resume/Cancel button.
6 times
CD-R tray guide open (during
printing to paper). [1851 /
1856]
*1
Close the CD-R tray guide, and
press the Resume/Cancel button.
7 times
*1
No CD-R or DVD-R. [1002] After setting a CD-R or DVD-R in the
tray, set the tray in the tray guide,
and press the Resume/Cancel
button.
8 times Warning: The waste ink
absorber becomes almost full
(approx. 95% of the maximum
capacity). [1700]
Pressing the Resume/Cancel button
will exit the error, and enable
printing.
In repair servicing, replace the
bottom case unit (QM2-1249), or the
ink absorbers (QC1-4222 / 4223 /
4224 / 4263 / 4264 / 4864).
The service call error, indicating
the waste ink absorber is full, is
likely to occur soon.
To Next Page
Loading...
