1
2
3
4
5
7
8
9
6
TOP
Back Previous Next
1-8
Table of Contents
Index
Advanced Send
Features
Advanced Copy
Features
Network
Remote UI
System Monitor
System Manager
Settings
Reports and Lists
Troubleshooting
Appendix
1. Press [Additional Functions].
2. Press [ ] or [ ] to select <TX/RX
SETTINGS>, then press [OK].
3. Confirm that <COMMON SETTINGS> is
selected, then press [OK].
4. Confirm that <TX SETTINGS> is selected,
then press [OK].
5. Press [ ] or [ ] to select <SEND
SETTINGS>, then press [OK].
6. Confirm that <TX FILE NAME> is displayed,
then press [OK].
7. Use the numeric keys to enter the
document’s name (up to 24 characters), then
press [OK].
8. Confirm that <SUBJECT> is displayed, then
press [OK].
9. Use the numeric keys to enter the subject (up
to 40 characters), then press [OK].
10.Confirm that <MESSAGE TEXT> is displayed,
then press [OK].
11.Use the numeric keys to enter the message
body text (up to 140 characters), then press
[OK].
12.Confirm that <REPLY-TO> is displayed, then
press [OK].
13.Use the numeric keys to enter the reply-to
address (up to 120 characters), then press
[OK].
14.Confirm that <E-MAIL PRIORITY> is
displayed, then press [OK].
15.Press [ ] or [ ] to select the priority
(<NORMAL>, <LOW> or <HIGH>), then press
[OK].
16.Press [Stop] to return to the standby mode.