76 Video
mode:
• All displays on
• Regular displays only (removes the histogram and information icons)
• All displays off
* Pressing will turn off most of the icons and displays that appear automati-
cally but will not remove onscreen displays that were turned on manually (for
example, onscreen markers, the audio level meter or the joystick guide).
**Only displayed in record pause mode, not while recording.
Digital Tele-Converter
Using the digital tele-converter, you can digitally increase the focal
length of the camcorder by a factor of approx. 1.7 and record the
enlarged image at full HD resolution.
1 Open ( ) the joystick guide.
2 Select ( ) [ Tele-converter] and press
.
appears and the center of the screen will
be enlarged approximately 1.7 times.
About the Full-Screen Display
During the playback of movies and photos on a TV or monitor set to
fullscreen display, you may notice that the picture on the TV is slightly
broader than the picture normally shown on the camcorder’s screen.
In record pause mode, press repeatedly until appears on
the screen, to display exactly the same picture that can be seen during
fullscreen playback.
About the Data Code
With every scene or photo recorded, the camcorder keeps a data code
(date/time of recording, information about the camera setup, etc.). In
mode, this information is displayed on the bottom bar and as
information icons; in mode, you can select the information to be
displayed with the [Data Code] setting.
DISP.
DISP.
Operating modes:
Tele-converter
To Next Page
Loading...
Need help?
General
Weight and Dimensions
