Need help?Do you have a question about the Canon MG8150 and is the answer not in the manual?
General| Functions | Print, Copy, Scan |
|---|---|
| Print Resolution | 9600 x 2400 dpi |
| Print Speed (Black) | 12.5 ipm |
| Print Speed (Color) | 9.3 ipm |
| Scanner Type | Flatbed |
| Borderless Printing | Yes |
| Connectivity | USB, Ethernet, Wi-Fi |
| Paper Sizes | A4, A5, B5, Letter, Legal, Envelopes |
| Ink Cartridges | CLI-526BK, CLI-526C, CLI-526M, CLI-526Y, PGI-525PGBK, CLI-526GY |
| Ink System | 6-color individual ink tanks |
Follow Connection Checklist and search for access point again.
Turn access point off and on, then search for access point again.
Enable SSID broadcast or disable stealth mode, then search for access point.
Check if WPA/WPA2 Enterprise is used as security protocol.
Ensure DHCP function of the access point is active.
Check if access point automatically creates WEP keys.
Check if MAC address filtering is enabled on the access point.
Check WEP key number usage or select WEP key number directly.
Make sure the DHCP function of the access point is active.
Are you using an access point that automatically creates WEP keys?
Check if MAC address filtering is enabled on the access point.
Select the correct access point or use multiple access points.
Select 'Use multiple Access Points' and follow subsequent operations.
Verify the entered access point name/network name (SSID) is correct.
Follow Connection Checklist and proceed with setup.
Turn the access point off and on, then proceed with setup.
Check if MAC address filtering is enabled on the access point.
Check if WPA/WPA2 Enterprise is used as security protocol.
Ensure DHCP function is active or specify IP address.
Re-enter network key if DHCP is active and perform setup again.
Message appears when multiple access points are detected. Wait and reconfigure settings.
Check access point and configure WPS settings again.
Follow Connection Checklist and click Update.
Confirm network connection status is Active.
Check if IP filtering is enabled on the network device.
Ensure DHCP function is active on the network device.
Check if privacy separator feature is enabled on the access point.
Message appears when machine cannot be detected. Click Back to perform detection again.
Confirm network connection status is Active.
Check if IP filtering is enabled on the network device.
Ensure DHCP function is active on the network device.
Check if privacy separator feature is enabled on the access point.
Check access point settings for forgotten network name, security protocol, or network key.
Wait for IP address assignment, restart computer, and search for machine again.
Instructions for entering characters using the on-screen keyboard.
Procedure to directly enter access point name and security settings on the machine.
Guide to manually specifying the machine's IP address for IPv4.
Steps to reset the machine's LAN settings to their default state.
Verify computer and network device configuration and connectivity.
Ensure the machine and network device (router, access point) are turned on.
Install access point and machine in open space, away from interference.
Verify access point operates in IEEE802.11b, g, or n (2.4 GHz).
Confirm the Wi-Fi lamp is lit blue.
Ensure Ethernet cables are connected to the LAN side of the router.
Verify wired LAN is enabled.
Check if the firewall function of security software is active.
To Next Page
