IdDCamcorder,VIX_ANG21A / VIX_AHG20A systems
Thisdevice complies with Part15 of the PCCRules.Operation is subject to the following two conditions: (1) Thisdevice may'not cause
harmful interference, and(2) this device must accept any interference received, including interference that may cause undesired
operation_
Note: Thisequipment has been tested and found tocomply with the limits for c_assBdigita_device pursuantto Part15 of the FCC
Ru_esThese limits aredesigned to pros!de reasonable protection against harmful interference in a residential installation. This
equipment generates usesand can radiateradio frequency energy and, if not installed anduse in accordance with the instructions,
maycause harmful interference to radiocommunications. However, there is no guarantee that interference win not occur in a
)articular installation. _fthis equipment doescause harmful interference to radioor television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try tocorrect the interference byone or more ofthe following measures:
Reorientor relocate the receiving antenn&
Increasethe separation between the equipmentand receiver
Connect the equipment into an outlet on a circuit different from that to 'which the receiver is connected.
Consult the dealer or art experiencedradio/_! technician for help.
Thecable with the ferrite core providedwith the digital video camcorder must be used with this equipment in order to comply 'with
ClassB limits in Subparf Bof Part 15 ofthe FCCrules.
Donot make any changes or modifications to the equipment unless otherwise specified in the manual.
If such changes or modifications should be made you could be required to stopoperation of the equipment.
CanonU.SA. Inc_
OneCanon P_az&Lake Success, NY11042, US.A.
Te_No (516)320-5600
CAUTION:
TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.
Important Warning
CAUTmON:
TO REDUCE THE RISK OF ELECTRIC
SHOCK, DO NOT REMOVE COVER (OR
BACK). NO USER-SERVICEABLE PARTS
mNSIDE. REFER SEBWCING TO QUALIRED
SERWCE PERSONNEL.
The lightning flash with arrowhead symbol,
within an equilateral triangle, is intended to
s_ert the user to the presence of uninsuIated
"dangerous voltage" within the product's
enclosure, that may be of sufficient
magnitude to constitute s risk of electric
shock to persons.
The exclamation point, withth an equNateral
triangle, is thtended to alert the user to the
presence of important operating and
maintenance (servicing) instructions in the
_iterature accompanying the product.
To Next Page