67
Setting Up Linked Shooting
5
Set up the master camera.
Configure the settings on the master camera
following steps 1-3 on the previous page, and then
select [Master].
X The following screen is displayed.
6
At this point, switch to setting up the
slave cameras.
On the slave cameras, select [OK].
7
Check the number of slave cameras.
X On the master camera LCD monitor, the number of
slave cameras detected is displayed.
8
Establish the connection.
On the master camera and all slave cameras,
select [OK].
X A screen is displayed as the connection is tested.
The information you specified is stored on the
cameras. It is not stored on the transmitters.
To Next Page
Loading...
Need help?
General
