Canyon CNS-DC3 - Timer Mode; Pacer Mode

EN - 3
button again to display next lap time. The lap time display will return
to counting display automatically after 10 seconds.
z Press and hold [L/R] for 2 seconds to reset counter.
z During split time display, press and hold [M] to recall all lap times
and total lap times accumulated.
z Press [S/S] and [L/R] to review each lap time and total lap times
accumulated.
z Press and hold [M] to exit lap time display and back to chronograph
display.
Timer Mode
z Upon entering, the Timer Mode indicator TMR will be displayed at the
top of screen.
z Press [L/R] to cycle through quick set values of countdown timer.
Press [S/S] to start countdown. The residual time will be displayed
on the screen.
z Press [S/S] during count-down to pause. Press the button again to
resume countdown.
z Press [L/R] to reset count-down timer to target time.
NOTE:
The device will beep once per minute when the timer reaches last 10
minutes, once every 10 seconds when timer reaches last one minute, and
once every second in the last 5 seconds. It will also beep for another 30
second when timer reaches target time.
Pacer Mode
z Upon entering, the Pacer Mode indicator PCR will be displayed at the
top of screen.
z Press [S/S] to generate beeps at a pre-defined pacer rate. Press the
button again to stop.
z The step counter increases one counter per beep.
z Press and hold [L/R] to reset step counter. During Pacer Mode, press