EN - 6
North which is slightly different from the true North. Please refer to
section below for more details.
z Please perform compass calibration under the following conditions:
1. Using the device for the first time.
2. When the magnetic distortion icon OFF CAL indicator is flashing.
3. After battery replacement.
4. When the device was calibrated at a distanced location.
z To acquire a more accurate measurement, please avoid using the
device under the following conditions:
1. When the device is in vicinity of magnets or magnetized objects.
2. When the device is in vicinity of electrical appliances.
3. When the device is inside a moving object or a reinforced concrete
building.
z Turn the device until the navigation arrow is pointing at the direction
of desired object for measurement.
z Press [L/R] to enter Compass mode and to display corresponding
compass direction and compass bearing.
z The bar graph pointer will be pointing at the direction of magnetic
North.
z Press [S/S] to toggle display of normal/backward bearing directions
of current object.
z The backward bearing indicator ª will be displayed at top of screen.
z The backward bearing will return to normal bearing automatically
once the device enters standby mode or manually switched back to
Current Time Mode.
z Press [L/R] to fix/release current compass readings.
z The compass lock indicator will be displayed at the top of screen.
z The compass lock will be released automatically once the device
enters IDLE mode or manually switched back to Current Time Mode.
To Previous Page
Loading...
