19
31
WARRANTY LIMITATIONS
Warranty does not cover repairs caused by:
- Malfunctions caused by water scale and by failure to periodically de-scale the unit
- Malfunctions caused by operating the machine at voltages other than that specified on the
nameplate
- Malfunctions caused by improper use or non-adherence to the instructions for use
- Malfunctions caused by alterations made inside the machine
Problem
Selecting the
distribution button
(3)
(D) (E) you
cannot get a
beverage.
Solution
1) Fill the tank with water
2) Check if the water tank is well located.
3) Lift the lever to permit air outlet take the capsule
off and wait for a while to let the pump be cool ,
close the lever again and select the distribution
button(3)
(D) (E).
If you cannot solve the problem, you are
kindly requested to contact your service center.
Coffee tastes sour
The lever (1) will not
slide properly.
Press the start button (3)
(D) (E), then open and close the lever (1) several
times while water is being dispensed.
-the machine was not rinsed
properly after descaling
- re-rinse the machine
Problem
Coffee/tea is no longer
dispensed
Coffee/tea is cold
A few drops come out of the
dispenser, especially when the
machine is warming up
The pump is too noisy
It is not possible to dispense
coffee, tea, or boiling water
Causes Corrective action
- the tank is empty
- the pump is defective
- fill the tank
- contact the dealer
- the water tank is not fully seated
- pompa difettosa
- seat the tank properly
- contact the dealer
- the heating system is defective
- contact the dealer
- the tank is empty
- the water tank is not seated
properly
- fill the tank
- seat the tank properly
- this is not a fault - it is normal for a few drops to
come out, this is not a defect
To Next Page
Loading...