Caple CM461 - Dispensing Hot Water; Dispensing Steam; Programming Ground Coffee Quantity

26
27
GB
9. DISPENSING HOT WATER
To dispense hot water, suitably position the water/steam
nozzles, see Fig. 10.1
• Position a container below the water/steam nozzle.
• Press the hot water button.
• Press the START button with 10 seconds from
making your selection. The water will be dispensed
as long as the button is pressed; to stop dispensing,
release the button.
ATTENTION: if the start button is not pressed
within 10 seconds, the function is disabled. If
you wish to dispense a beverage, you will have
to repeat the procedure.
We recommend that you do not dispense hot
water immediately after dispensing steam.
10. DISPENSING STEAM
To dispense steam, press the steam button. The
corresponding indicator light will ash for 15 seconds.
As soon as the indicator light stops ashing and remains
steady on, the machine is ready to dispense steam.
• Place the container with the liquid to be heated below
the steam nozzle.
• Completely immerse the nozzle in the liquid to be
heated.
• Press the START button within 10 seconds from
making your selection and wait for the steam to come
out.
ATTENTION: if the start button is not pressed
within 10 seconds, the function is disabled. If
you wish to dispense a beverage, you will have
to repeat the procedure.
The steam will continue to ow until you release the
START button.
If you are preparing milk for a cappuccino, we
suggest that you agitate the
milk container for better results.
11. PROGRAMMING THE QUANTITY OF
GROUND COFFEE
You can choose from three strengths of coffee:
• light;
• medium;
• strong.
To change from one type of coffee to the other, just
press the button as shown in Fig. 12.1. The LED for the
selected coffee will light (in Fig. 12.2, light coffee).