Instruction manual Di48226
Please keep this instruction manual for future reference
PROGRAMMING THE DISHWASHER
STARTING A WASH CYCLE:
» Pull out the lower and upper baskets, load the dishes and push them back. It is recommended
to load the lower basket first, then the upper one (see the section entitled “Loading
the Dishwasher”).
» Pour in the detergent (see the section entitled Salt, Detergent and Rinse Aid).
» Insert the plug into the socket. The power supply is 230 VAC /50 HZ, the specification of the
socket is 10A 250VAC. Make sure that the water supply is turned on to full pressure.
» Open the door, press the power button, and the On/Off light will turn on.
» Choose a programme, the response light will turn on. Then close the door, the dishwasher will
start its cycle.
CHANGE THE PROGRAMME
» A cycle that is underway can only be modified if it has only been running for a short time.
Otherwise, the detergent may have already been released, and the appliance may have already
drained the wash water. If this is the case, the detergent dispenser must be refilled (see the
section entitled “Loading the Detergent“).
» Open the door, press the Programme button for 3 seconds, the machine will be in standby
state, then you can change the programme to the desired cycle setting (see the section entitled
“Starting a wash cycle”).
NOTE:
If you open the door during a wash cycle, the machine will pause. The programme light will stop
blinking and the buzzer will sound every minute until you close the door. After you close the door,
the machine will continue working again.
FORGOT TO ADD A DISH
A forgotten dish can be added any time before the detergent cap opens:
» Open the door a little to stop the washing.
» After the spray arms stop working, you can open the door completely
» Add forgotten dishes
» Close the door
» The dishwasher will start running again
WARNING:
It is dangerous to open the door mid-cycle, as hot steam may scald you.
To Next Page
Loading...
