Please keep this instruction manual for future reference Instruction manual VAP2/3IN1, VAPQ2/3IN1, JOY3IN1 9
BOILER
WAT E R FILTER
98º
Steam release valve
(to be connected
to plumbing)
T-piece connector
Push fit to
thread adaptor
98˚ Water
C [Filtered]
H C
C
Hot & Cold Water
Normal Cold Water
98˚ Water from Boiler
Normal Hot Water
Mains
Hot
Mains
Cold
INSTALLING THE VAPOS 3IN1 STEAMING HOT WATER TAP
1. In order to prevent an electric shock, do not place electrical wires, plugs or the dispenser in a
wet or damp location.
2. If any cables or sockets have signs of damage, do not connect the appliance to the power
supply. These should be replaced by a Caple Service agent.
3. When installing the dispenser, you should allow 10 to 15cm of space around it for ventilation.
4. You must never use a spare part which is not recommended by Caple.
5. The temperature adjustment controls the water temperature, not the water flow.
6. Do not ‘dry heat’ the water tank as this can cause heating of the pipes and the water tank will
become damaged. You must ensure the tank has been filled with water before switching the
boiler on at the mains.
To Next Page
Loading...