23Please keep this instruction manual for future reference Instruction manual Wi6161
HOW TO INSTALL THE FURNITURE DOOR
NOTE:
If a handle is required, please ensure this is installed in an appropriate position before the
furniture door is installed.
1. Fully open door.
2. Starting at the corner, pull the gasket away from the door. As per Fig A.
3. Continue to pull the gasket free from the gasket channel.
4. Upon removal, lay gasket down on a flat surface.
5. Secure the furniture door panel to the appliance door using clamps (see Fig. B).
6. Using a 3 mm drill bit, drill 6 pilot holes into the wood panel 12 mm deep using the holes
in the door frame as a guide.
NOTE:
It is important to ensure that all drilled holes are drilled to the correct depth in order to avoid
splits in the wood when hardwood is installed. You must also take care not to drill all the way
through the door.
7. Locate 6 of the M4x34 mm screws provided with your unit.
8. Using a Phillips screwdriver, place one screw into each of the 6 pilot holes and screw into
the door, as per Fig C. Be careful not to over tighten screws. Ensure the screws sit flush
against the bottom of the channel. Remove clamps from door. Note: If panel requires
additional adjustment after removing clamps, slightly loosen each screw and adjust panel
as necessary. Tighten screws upon completion.
9. Starting at the corners, re-install the gasket into the gasket channel in the frame, by
pushing firmly into place. Make sure the gasket is fully seated into the channel.
To Next Page
Loading...
