4
Always wait 4 minutes before restarting the unit if operation has been interrupted.
Installation of Shelves
To fit or remove the shelf, tilt the shelf as per the diagram and simply pull out, or push the shelf in
until it sits on the support brackets securely.
Fitting the supplied plinth(stainless steel plinth)
When the wine cellar is installed in its final position, the plinth should be fitted. Remove the
protective tape from the adhesive strips on the rear of the plinth and then place firmly in position
onto the bottom of the wine cellar cabinet.
THE FLOW OF AIR THROUGH THE GRILL MUST NOT BE OBSTRUCTED AT ANY TIME. FAILURE TO
ADHERE TO THIS WILL INVALIDATE THE GUARANTEE.
DEFROSTING/CONDENSATION
Your wine cabinet is designed with an “Auto-cycle” defrost system. When the RUN cycle is OFF, the
refrigerated surface of the wine cabinet (interior rear wall) defrosts automatically. The defrost water
is channeled into a drain pan which is located at the back of the wine cabinet next to the
compressor from where it evaporates.
HUMIDITY MAINTENANCE SYSTEM
The wine cabinet is equipped with a system for maintaining the correct level of humidity. If humidity
is too low, insert the small plastic reservoir on to the top shelf. Fill this reservoir 3/4 full with water.
Check the water level occasionally and refill as necessary.
CARE AND MAINTENANCE
Cleaning
• Turn off the power, unplug the appliance, and remove all items including shelves and rack.
• Wash the inside surfaces with a warm water and baking soda solution. The solution should
be about two tablespoons of baking soda to one litre of water.
• Wash the shelves with a mild detergent solution.
• Wring excess water out of the sponge or cloth when cleaning the control panel, or any
electrical parts.
• Wash the outside cabinet with warm water and mild liquid detergent. Rinse well and wipe
dry with a clean soft cloth.
To Next Page
Loading...
