EasyManuals Logo

Capstone 10012 User Manual

Capstone 10012
12 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
WARNINGS:
FOR SERVICE ASSISTANCE
CALL TOLL FREE 1.800.451.5368
It’s the consumer’s responsibility to ensure that the use of this rack complies with local regulations.
Do not cover license plates, and tail lights.
MINORS AND CHILDREN CANNOT BE ALLOWED TO PLAY OR STAND NEAR THIS PRODUCT.
This bike carrier has been designed to carry bicycles on most vehicles. Refer to your vehicle’s owner’s
manual for your vehicle’s specific guidelines.
This carrier is designed to carry bicycles only.
Do not mount to any type of trailer, RV, towed vehicle etc.
Always make sure the trailer is properly attached before each use.
Seller and manufacturer disclaim any or all liability for direct and indirect injuries or damages caused by
the improper installation, use, improper maintenance, or abuse of this product.
Remove baby seats, panniers, U-locks, or items that could detach from the bicycle.
Do not use bicycle covers, bicycle bras, or bikes equipped with rear disc wheel.
Not intended for off road use. Not intended for use on trailers or towed vehicles.
Locks are the only deterrents to thieves. CAPSTONE cannot be held liable for stolen bicycles.
Remove rack before entering a car wash.
Check all fastenings (nuts, bolts and straps) before each use.
Once a year, remove rack from car. Clean and inspect for damage.
Do NOT exceed maximum load capacity of the carrier (70lbs. max, 35lbs. max per bike).

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Capstone 10012 and is the answer not in the manual?

Capstone 10012 Specifications

General IconGeneral
BrandCapstone
Model10012
CategoryBicycle Accessories
LanguageEnglish