First-time Operation
13
Prior to using your Captiva Designs gas grill, verify that all of the following is true:
• The burner tube is free of any debris or obstruction.
• The proper gas type, gas connection, and regulator settings have been installed.
• You’ve checked for gas leaks.
• All packaging has been removed.
• All parts and components are properly in place.
• An installer-supplied manual gas shutoff valve is fully accessible.
Lighting the Appliance
USING THE OVEN
To begin:
1.
Make sure the oven has been leak tested and properly placed.
2.
Remove any remaining packing material.
3.
Light the burner using the LIGHTING INSTRUCTIONS below
• Your pizza oven will take approximately 10minutes to reach optimum cooking temperatures. If using in
colder temperatures, preheat and cooking times could take longer.
• After 10 minutes , put your pizza into the oven . Wait for 2 minutes , use the pizza peel to rotate the pizza
let another side close to the re, then put the door on again.
• Wait for 1 minute, rotate the pizza. Repeat this step for 2-3 times, your pizza is almost done.
• Different thickness will take different cooking times.
Easy step to cook your pizza
ENJOY YOUR CAPTIVA DESIGNS
1.
Make sure the control knob is in OFF position, and then turn the liquid propane cylinder
valve ON by slowly turningcounterclockwise.
2.
Push in and slowly turn the control knob anticlockwise until you hear a click and the
burner ignites.
3.
If burner doesn't light, turn the knob OFF, wait 5 minutes and repeat the lighting.
TO LIGHT WITH A MATCH
1.
If burner will not light after several attempts using the control knob, the burner may be lit with a match.
2.
If you have already attempted to light the burner using the control knob, wait 5 minutes for any gas to
dissipate.
3
. Insert a match into the matchstick holder, ignite the match and insert through the oven opening to the
burner.
4.
Push and turn the control knob to Max slowly, the burner should ignite immediately.
5.
If the burner does not light within seconds, turn the control knob OFF and wait 5 minutes and try again.
6.
If the burner does not light after several attempts, immediately close all gas valves and consult an
authorized service technician.
To Next Page