Power up phase, please donít move for 10 s;
still no output of servo-signals.
Off / conventional controls (glowing red)
Horizontal mode (glowing yellow)
Position mode (glowing green)
orange-
Power up:
Setup:
Normal operation: Color indicates the pilot channel position
Flickering green: not enough contrast,
only horizontal mode but .no position mode
For checking: switch to ìgreenî mode and hold helicopter
in different distances above ground by hand.
Trim button is pressed, and connect to AUX-Kanal
and assigned (via PC-adaptor)
Setup process
(step number = count of flashing)
Fault at selftest (LED flashes red) No output of servo-signals
(1x)
(2x)
(3x)
(4x)
(5x)
(6x)
(7x)
(8x)
No (during selftest)
Battery < 4V power up
Movement during power up phase, repeat power up
Instruments fault or too extreme temperature
Auto trim value at the limit
(reserved)
Unacceptable center divergence at automatic learning
process; at least one channel out of center?
LED dark : undervoltage < 4V
R/C-receiving
(Do not use for charge monitoring!)
(if necessary wait for temperature change to settle)
must be cleared and adjusted mechanically
No at automatic learning process R/C receiving
Complete neutral positions learning (then power off)
To Next Page
Loading...