- 2 -
1.3 Final Assembly and Installation
Unpack machine and check for any visible damage which may have occurred during transport. If a damage is detected
notify your dealer immediately.
This machine is shipped partly disassembled saw table, Mitre Fence and star knob have to be installed prior to use.
z Remove the wing nut and Hex. socket head cap screw the table.
z Place the table onto the upper table trunnion.
z Install to trunnion with 4 each serrated lock washer and hexagon
head screw M6x12.
z Attach the wing nut and Hex. socket head cap screw to table
with the wrench Hex.
z Place table insert into the table center hole (table insert with
wide slot for bevel cuts only).
z Place the star knob into the hole on the frame
After installation adjust the table so that the sawblade runs through the center of the table insert’s slot.
Centering the table
z Loosen the screws holding the lower table trunnion.
z Move table sideways as required, until sawblade runs through the
center of table insert.
To Next Page