CARDIOSTRONG TR20 - User Manual

Questions and Answers

D
Damon MerrittAug 12, 2025
Why is the heart rate fluctuating on my CARDIOSTRONG TR20?
- B
  Brandon GriffinAug 12, 2025
  If the heart rate reading on your CARDIOSTRONG Treadmill fluctuates or isn't recording, first ensure your hands are slightly moist when using the hand pulse sensors. Check all cable connections behind the console to make sure they are secure and inspect the cables for any damage. If you're using a chest strap, verify the battery status and ensure the electrodes are moist and positioned correctly below your chest.
R
Roger SantosAug 16, 2025
What to do if the console display is fluctuating on my CARDIOSTRONG TR20?
- J
  Jamie GriffinAug 16, 2025
  If the console display on your CARDIOSTRONG Treadmill is fluctuating or not lighting up, verify the treadmill is properly connected to the power supply. Turn the power switch off, then back on. Ensure the safety key is plugged in. Check all cable connections to confirm they are correctly connected. If the issue persists, contact customer service.
D
Dustin MorrisAug 20, 2025
What to do if E1 appears on CARDIOSTRONG TR20 Treadmill?
- M
  Mike DeanAug 20, 2025
  If the E1 error code appears on your CARDIOSTRONG Treadmill, remove and reinsert the safety key to restart the machine. If the error persists, check all cable connections. If the treadmill doesn't move after pressing START and displays E1, check for any obstructions. If the treadmill stops shortly after starting and shows E1, inspect all cables and the motor. If the issue remains unresolved, contact customer service.
L
lindsey44Aug 23, 2025
Why is the running mat slipping on my CARDIOSTRONG Treadmill?
- R
  robert54Aug 25, 2025
  If the running mat slips during usage on your CARDIOSTRONG Treadmill, the belt likely needs tensioning. Refer to the manual for instructions on how to properly tension and align the belt.
J
Joseph HallAug 27, 2025
How to adjust the belt on CARDIOSTRONG TR20?
- C
  Courtney FranklinAug 27, 2025
  If the belt on your CARDIOSTRONG Treadmill does not run in the middle during usage, first ensure the treadmill is placed on a stable, level surface. Then, refer to the operating manual for instructions on how to adjust and tension the belt.
P
princejamesAug 30, 2025
Why does the motor appear overloaded on my CARDIOSTRONG TR20 Treadmill?
- K
  Kathryn OneillAug 31, 2025
  If the motor of your CARDIOSTRONG Treadmill seems overloaded or the E1 error appears after a few minutes of use, the silicone applied to the deck and belt has likely dried out. You need to lubricate the deck again using silicone spray.
L
Luke MarshallSep 4, 2025
How to turn off silicone symbol on CARDIOSTRONG TR20 Treadmill?
- J
  James HillSep 4, 2025
  If the silicone symbol is illuminated on the console of your CARDIOSTRONG Treadmill, lubricate the machine with 100% pure silicone. Then, press the speed down button and the START button simultaneously until the symbol turns off.
R
Richard MooreSep 7, 2025
Why is the start button LED faintly glowing on my CARDIOSTRONG Treadmill?
- D
  Danielle SantanaSep 7, 2025
  If the LED on the start button of your CARDIOSTRONG Treadmill glows faintly and other LEDs are off, the machine is likely in power-saving mode. To exit this mode, hold the START button for one second.