Carefree Awning Stabilizer Pole Kit HD User Manual

070020-002r3 1 November, 2018
C AREFREE
AWNING STABILIZER POLE KIT - HD
A SUPPORT AND TIE DOWN KIT FOR VERTICAL ARM AND BOX AWNINGS DURING
PROLONGED USE
.
RV Accessories
NOTICE After opening the awning set the awning power switch to off to prevent the awning from
retracting when the supports are installed. Retracting the awning with the supports and tie-downs attached
can damage the awning.
NOTICE If it is necessary to adjust the awning pitch after staking, loosen the tension straps and lower the height
of the vertical support before adjusting the pitch. Failure to do so can cause damage to the awning.
CAREFREE’S LATITUDE AND VERTICAL ARM AWNINGS
1. Open the awning and set the desired pitch according to the product documentation.
2. Press the cradle over the pin on the
pole. No tools required. It is not
necessary to remove the cradle for
storage.
3. Place the support pole cradle under
the roller tube between the canopy
and endcap.
4. Loosen the locking knob on the
vertical support. Adjust the height of
the support then tighten the knob.
NOTICE Do not use the
supports to adjust the awning’s
pitch. Use the awning’s pitch
adjustments prior to installing the
supports.
The poles may be adjusted from 56" to
108".
5. Place a stake through the D-ring of
the tension strap. Then drive the
stake into the ground approximately
5'-6' in front of the awning.
6. Loop the strap over the roller tube.
Attach the D-ring to the hook on the
cradle.
7. Tighten the strap by pulling the open
end of the strap through the tension
adjustment rings.
8. Repeat for the other side.
NOTICE Always remove the supports before retracting the awning. Retracting the awning with the
supports and tie-downs attached can damage the awning.
Cradle
ast003
ast001
Stake through
D-ring
Tension Strap
(2 total)
Vertical Support
(2 total)
Loosen
5'-6'
Vehicle
Place D-Ring in
Hook on Cradle
Place Cradle under
Roller Tube Between
Canopy and Endcap
Tighten
Stake through
Foot
Tension Adjust
Rings
Locking Knob

Carefree Awning Stabilizer Pole Kit HD Specifications

General

Type	Awning Stabilizer Pole Kit
Material	Heavy-Duty Steel
Adjustable Height	Yes
Finish	Powder-Coated
Quantity	2 poles per kit
Diameter	1 inch
Included Components	2 poles
Compatibility	Most RV Awnings

Summary

CAREFREE LATITUDE AND VERTICAL ARM AWNING INSTALLATION

Initial Setup and Pitch Adjustment

Open awning and set desired pitch before installing supports. Follow product documentation.

Attaching Support Cradle

Press cradle over pole pin, then place under roller tube between canopy and endcap.

Adjusting Vertical Support Height

Loosen locking knob on vertical support, adjust height, then tighten knob.

Securing Tension Straps

Stake D-ring, loop strap over roller tube, and tighten using adjustment rings.

Key Safety and Usage Precautions

Follow critical notices to prevent awning damage during installation and retraction.

BOX AWNING INSTALLATION

Attaching Lead Rail Grip

Press lead rail grip over pole pin, then place jaws over lead rail edge.

Adjusting Support Height and Securing

Loosen locking knob, adjust support height, tighten, and secure tension strap.

Important Usage and Safety Notices

Observe notices from page 1 and always remove supports before retracting awning.