6
Default IP Connection
Default IP connection setup for boss micro
This is useful when resetting the network settings
You will need:
• boss micro and power supply
• Windows PC or laptop
• Ethernet cable
To setup a direct connection on boss micro LAN port, you need to first setup your PC
network to match the path of the default IP address of 172.16.0.33 .
To do this, go to:
Settings >> Ethernet >>
Change adapter options >>
Select the ethernet device and select
“Change settings of this connection”
Choose Internet Protocol Version 4
(TCP/IPv4) and go to properties.
Use the following IP address
IP address 172.16.0.32
Subnet mask 255.255.0.0
Default Gateway 172.16.0.1
To activate the default IP address, after powering up the unit, wait for approx. 30-40
seconds. Press and hold the 2nd IP button for about 3 seconds. Once released the radio
module LED will blink green if successful.
Once activated, the default address is active for 1 hour.
Default IP
Setup
button
Radio module
LED
To Next Page
Loading...
