Carel ir33+

10 • Carel IR33+ Controller - IR33+ Parameters Verify and/or Change
CAREL IR33+ CONTROLLER
SETTING PARAMETERS ON THE CAREL IR33+
To set a parameter after you have entered the password, perform the following steps. See picture below for key locations.
1. Press [UP] arrow key until parameter you want to see is displayed.
2. Press [SET] to enter parameter setting
3. Press [UP] or [DOWN] arrow to set parameter to desired setting.
4. Press [SET] again to exit parameter setting.
Repeat these steps until you have changed all parameters.
Donotforgettoconrmparametersaftersettingthem.
Seestep7fromthepreviouspageonhowtoconrmsettings.
1
2
3
3
4
IR33+ Parameters Verify and/or Change