Standard Shelter
Cod. +030221471 – Rel. 2.0 – April 01, 2003
34
20 INITIAL INSTALLATION AND UPDATING THE SOFTWARE
When the boards are installed for the first time, they must be programmed by DOWNLOADING the application program to the Flash memory on the
pCO2-pCO1; this operation can be performed in two ways: using a PC or a hardware key.
20.1 DOWNLOADING THE PROGRAM FROM A HARDWARE KEY
The hardware key available for all the versions of the pCO2 (code PCO201KEY0 1Mbyte version - PCO202KEY0 2Mbyte version) and the pCO1
medium and small (code PCO100KEY0) creates exact copies of the software contained on a master pCO2-pCO1. This is normally used on the
assembly line or in the field for programming the pCO2-pCO1, where updating the software by PC would be more complicated.
For further information refer to the instruction sheet supplied with the hardware key.
20.2 DOWNLOADING THE PROGRAM FROM A COMPUTER
The kit code PC485KIT00 (232-485 converter) and the WinLOAD 32 program are required; these are used to upload the program files to the pCO2
or pCO1.
For further information on the installation and use of Winload 32, contact CAREL.
20.3 INSTALLING THE DEFAULT PARAMETERS
The default parameters are the values assigned by CAREL to the main operating parameters of the application program. These values are assigned
automatically when downloading the software the first time to a pCO2 or pCO1 board using Winload, or if the version of the software is upgraded.
If necessary, the default parameters can be installed manually by the user, at any time, by accessing the screen V0 (see the list of the screens).
WARNING: this operation must be carried out with extreme care, as it deletes all the parameters from the memory and replaces them with the
default values. NB: the previous parameters cannot be restored after this operation
20.4 SELECTING THE LANGUAGE
The default language is English, however the following options are available: Italian, French, German, Spanish. To change the language, proceed as
follows:
1. Press the Maintenance button if using the external terminal, or the PRG button if using built-in terminal, and confirm the first item on the
MAINTENANCE menu by pressing Enter;
2. The main program screen is displayed, showing the code, the version and the date. Press Enter to move the cursor to the last row;
3. Select the language required using Up or Down.
To Next Page
Loading...
Need help?
General
