Carex B651 User Manual

Assembly Instructions
Bath and Shower Seat with Back
Made in China
42-B65100_10 ©2014
Carex Health Brands
PO Box 2526, Sioux Falls, SD 57101-2526
Phone 800.526.8051 www.carex.com
B651/B652
Seat x 1
Backrest x 1
Leg Extensions x 4
Washer x 5
L Bars x 2
Medium Screws x 1
Long Screws x 4
U Bar x 2
Labeled “1”
and “2”
1
Place seat face down on a table or counter
with the seat lip near the edge of the table.
Place U bar labled “1” on the groove in the seat
so the “1” on the bar is next to the “1” on the
seat.
Place the U bar labled “2” on the seat so the “2”
on the bar is next to the “2” on the seat.
2
1
1
2
Find the 1 medium sized screw - Warning
- medium screw must be used for the next
step or damage to the seat will occur.
Place medium screw with washer into center hole
through both U bars and into the screw hole in the
seat.
Contour of washers should match curve of bar.
2
1
1
2
2

Carex B651 Specifications

General

Brand	Carex
Model	B651
Category	Indoor Furnishing
Language	English

Summary

Bath and Shower Seat Assembly Instructions

Prepare Seat and Attach U Bars

Place seat face down and attach labeled U bars into designated grooves on the seat.

Secure U Bars with Medium Screw

Use the correct medium screw and washer to attach U bars to the seat, ensuring proper fit.

Attach Backrest to L Bars

Connect the backrest to the L bars by aligning and inserting pop pins through the holes.

Attach L Bars and Tighten Screws

Mount L bars to U bars using long screws, then tighten all screws for stability.

Install and Adjust Leg Extensions

Insert leg extensions into the seat base, ensuring pins engage, and adjust for equal height.

Final Checks and Placement

Verify stability, ensure all pins/screws are secure, and place the assembled unit.